Replacement parts for vintage appliances

For vintage appliances (pre 1960's), we typically cannot reference any parts based off of model numbers.  The main thing we need, regardless of make, are photos of your appliance [two minimum; both front view; one with door(s) open and one with door(s) closed] in order to see if we have parts available.  Also, for specific parts, if you can provide us with a photo of the part(s) in question, that would be most helpful.   For info about specific antique parts, or to order parts and gaskets for your vintage appliance, contact Austin at 706-782-3132, or send him an e-mail at parts@antiqueappliances.com

Need parts for an appliance built after 1960? Click Here.

There will be a 30% restocking fee for all returned parts.

Special order items are not returnable.

Shipping charges are not refundable.

	Chromolax replacement surface burner with trim ring and drip pan. Comes as a set. Available in 6" or 8" sizes. Fits all vintage stoves that use a 3 wire 220 volt interior wiring system 8" set (Large) 6" set (Small)
	GE Replacement Surface Element. Similar to the Chromolax burners, but specifically designed for use on 1940s and 1950s GE and Hotpoint stoves. Available in 6" and 8" sizes. Please designate whether your original burners have trim rings attached or seperate.
	Ranco refrigerator cold control. Fits virtually any manual defrost refrigerator made in the 1940's and 50's. Kit comes with multiple mounting brackets and several shaft adapters so that the original control knob can be reused.
	General Electric infinite heat surface control switch. Fits virtually any electric stove, that uses rotary heat controls, made during the 1940's and 50's. Comes with shaft adapters to accommodate most application and allow the reuse of the original knob.
	Spring coil heating elements. This type heating element was used in bake and broil burner assemblies as well as many stove top burner applications. Use of this restring element does require reuse of the original burner frame assembly.Bake and broil assemblies generally require two (2) restring kits. Surface burners generally use one (1).